GE 10 AZA Owner's Manual page 15

7
Install the Case in the Window
Peel off the backing from the bottom
A
window gasket.
Place the gasket on the stool and over the
B
brackets, even with the rear edge, sticky
side down.
Carefully slide the empty case into the
C
window until the holes in the case line up
with the holes in the panel angles.
NOTES:
The case should have a 1/8 minimum tilt
toward the outside.
Be sure the seal gasket and panel gaskets
remain in position and do not roll with the case.
Lower the window so it fits behind the panel
D
tabs. Insert the 4 type A screws through the
holes in the case and into the panel angles,
2 on each side.
Panel
tabs
Bottom window gasket
Case holes
Case
screws
With the window closed, mark where the
E
window sash meets the case.
Peel off the backing from the case top gasket.
F
Hold on to the case, open the window, and
G
place the gasket along the mark on the case.
Put the gasket on top
of the case where the
window will close.
Place the vinyl window gasket over the case
H
top gasket. Insert the panel tabs through the
slits in the gasket. Cut the gasket on each side
to the width of the window.
Panel
tab
Close the window tightly on the vinyl gasket.
I
Bend the gasket forward to expose the panel
tabs. Drill pilot holes into the window sash.
Vinyl window
gasket
Attach the panel tab to
the window on each side
with a type D screw.
15