GE 10 AZA Owner's Manual page 14

Installation for models AJES and AJHS—with filler panels.
Read these instructions completely and carefully.
6
Measure, Cut and Install the Filler Panels
Measure from the edge of the panel marks
A
(see Prepare the Window) to the inside of the
window track on each side. (A and B)
A
Left side
Mark the A and B measurements on each
B
side of the filler panel board. Cut the panels
and discard the center piece. Note position
of the notches.
Put together the panel assemblies. Remove
C
the paper backing from the case side gasket
and attach it to the angle. Push a pencil point
through the gaskets to locate the holes in
the angles.
14
Sill
Window track
13 3 ⁄ 13 3 ⁄
8 8
Width of the air conditioner
(panel marks)
B A
Right side Left side
Filler Panels
Cut panels
and discard
center piece
Gasket
Angle
B
Gasket
Right side
Install the panels in the window. Place
D
the spring clips 3 from the top and the
bottom. Squeeze and push the clips to fit
in the window track and the tab into the
sill support.
Hook the tab into the
sill support
Angle
Panel
Tab
3
Type C
(painted
screws)