Unpacking - GBC Laminator Operation And Maintenance Manual

F-60 Operation and Maintenance Manual
8QSDFNLQJ
NOTE
ALL SHIPMENTS ARE EX- WORKS. At our dock title
passes to the buyer. Please review your insurance cov-
erage prior to shipment, as you are responsible for all
subsequent freight charges and risks. Before signing
the Bill of Lading you should be sure to inspect the
crate and/or pallet for signs of damage or missing
items; if applicable, make a note of this on the Bill of
Lading.
The F-60 Laminator is shipped in a wood crate on a
skid.
The unpacking process requires at least two
people. You can be severely injured or crushed.
Tools required:
• Phillips head screwdriver
• Adjustable wrench
To uncrate the laminator:
1. Remove the top of the crate and sides 2 and 3 as
shown in Figure 2-2.
1
ING
WA RN UN G
HT
AC GAR DE
MISE EN
burn r
h and Stay clea rs.
Crus haza rd. ing hine re rolle and
of mac mov befo roll
raise Stop ning . Reorder No.1033R-PT
clea 800-748-0241 Inc.
©1994 HCS,
RN ING
WA TUN G
ACH E
EN GARD
MISE
Figure 2-2: Removing the Crate
© GBC Pro-Tech 1998 July
WARNING
Install
Screws
2. There are two hold down bridges that are con-
nected to sides 4 and 5. Remove the hold down
bridges and then remove sides 4 and 5.
Do not allow the top to fall into the crate. It can
damage the laminator.
Do not put packing screws on the floor. They can
cause problems when trying to roll the machine
into position.
A second person must support the side
labeled (5) in Figure 2-2. It can fall and damage
the laminator.
3. The infeed pressure plate and ramps are attached to
the skid. Remove them and set them aside for later
installation.
2" x 4"
Saddle
Skid
2" x 4"
Skid
Saddle
Figure 2-3: Skid Configuration
Do not use a knife or other sharp instrument
during installation or while servicing the
laminator. You can cause irreparable damage to
the rolls.
Installation
CAUTION
Heaters
2" x 4"
Saddle
Skid
Lag Bolt
Lag Bolt
CAUTION
2-3