Lubrication - GBC Laminator Operation And Maintenance Manual

F-60 Operation and Maintenance Manual
Tools required:
1
• / " hex wrench
8
• High temperature grease or lithium grease
• Grease gun
To lubricate the laminator:
Do not lubricate the laminator when it is hot. You
can be burned.
Remove and lockout power from the laminator
while you are performing this procedure. You
could be severely shocked, electrocuted, or get
your fingers caught in the drive mechanisms.
1. Remove the drive and control side cabinet covers
1
using the / " hex wrench by removing the eight
8
screws holding each cover in place. Gently rotate
the cover around the clutch knob to allow access to
the lubrication points.
2. Using the grease gun, lubricate each grease fitting
with one squirt of high temperature grease.
3. Lubricate the chain using a soft cloth and automo-
tive oil.
4. Replace the cabinet covers, close the safety shields
and reapply power to the laminator.
© GBC Pro-Tech 1998 July
WARNING
WARNING
Maintenance and Troubleshooting
For machine parts and technical service in North
America, please call: 1-800-790-7787. Please provide
serial number when calling for service. In Europe,
please call: +44 (0) 1844 202 440 or fax: +44 (0) 1844
202 441.
For film and application questions in North America,
please call 1-800-236-8843. In Europe, please call: +44
(0) 1844 202 440 or fax: +44 (0) 1844 202 441.
4-5