Download Print this page

Setup - Toshiba C2402 - SD - DVD-ROM Drive User Manual

Dvd-rom mobile drive
Hide thumbs


SETUP – SD-C2402
Toshiba recommends that only trained professionals install this DVD-ROM drive into your
Installation Notes
The SD-C2402 DVD-ROM drive has no jumpers that need to be set
Mounting orientation: 15° (horizontally), 15° vertically (volume control in down position), 30°
(drive with volume control in up position).
When mounting drive use 4 M2-PO.4 tapping holes located on the left and right sides of drive.
When mounting drive, the tightening torque of the four screws must be even. Recommended
screw tightening torque is 2Nm
For clearance around the front bezel, it is recommended that a clearance of more than 0.8mm
should be left in all directions.
Software Driver
Toshiba's SD-C2402 drive does not require any unique device drivers for Windows '98/2000/XP/NT.
After installing your drive and re-booting, your system should recognize your drive. Win '98/2000/XP/NT
Operating Systems support all Toshiba's ATAPI drives natively. If you prefer using DOS, download the
ATAPI driver from our web site.



  Related Manuals for Toshiba C2402 - SD - DVD-ROM Drive

This manual is also suitable for: