Download  Print this page

Setup - Toshiba SD-M1912 User Manual

Dvd-rom drive
Hide thumbs

Advertisement

SETUP – SD-M1912 DVD-ROM
The following steps must be performed to properly install your drive:
Set Drive Jumper Settings
Connect Audio Cable (optional)
Attach IDE BUS Cable
Attach Power Cable
Mount Drive
Jumper Settings
The mode select jumpers are 6 straight angle pins located on the rear of the DVD-ROM drive.
By placing a jumper on the pins, you can select the following functions:
CS
SL
MA
In most installations, jumper should remain in the MA position (factory default). It is recommended that
you install your DVD-ROM drive only on the secondary IDE BUS. If you are installing on primary IDE
BUS, your hard drive would then be the Master, and you should set your DVD-ROM drive to the Slave
position (SL)
3
Drive is configured using host interface signal CSEL
Configures drive as Slave
Configures drive as Master (default mode)
Figure 1.Mode Select Jumper
Figure 2.Jumper Locations

Advertisement

loading

  Related Manuals for Toshiba SD-M1912