Table of Contents
Advertisement
Navigation System
(Optional)
Switching the Navigation Screen
(Optional)
If an optional Alpine Navigation System is connected to the
IVA-W520R, the Navigation screen can be displayed on this unit.
1
Touch [SOURCE] on the main source screen.
The source screen appears on the display.
2
Touch [NAV.].
The Navigation screen is displayed.
The operation is possible with the supplied navigation
remote control.
For navigation operation, refer to the Owner's Manual of the
navigator.
• The Navigation mode is selected in "Setting the VISUAL Soft
Button" (page 42). The navigation mode is activated through the
[VISUAL] Button without interrupting normal audio.
• If the Navigation mode menu is not displayed on the main menu
screen, select ON in "Setting the Navigation Mode" (page 41).
• When the Navigation System is on and in guidance mode, the voice
prompts and navigation map interrupts the current audio source.
Auxiliary Device
(Optional)
Operating Auxiliary Devices (Optional)
To operate your devices connected to the AUX terminals on the rear
panel of IVA-W520R (AUX mode) or to the BLUETOOTH interface
connector by using a special conversion cable (KCE-237B) (sold
separately) (AUX+ mode), follow the procedure described below.
WARNING
It is dangerous (and illegal in many states) for the
driver to watch the TV/Video while driving the vehicle.
The driver may be distracted from looking ahead and
an accident could occur.
Install the IVA-W520R correctly so that the driver
cannot watch TV/Video unless the vehicle is stopped
and the emergency brake is applied.
If the IVA-W520R is not installed correctly, the driver
will be able to watch the TV/Video while driving the
vehicle and may be distracted from looking ahead and
cause an accident. The driver or other people could
be severely injured.
• If you try to activate the auxiliary device while driving, the display
will show the warning-PICTURE OFF FOR YOUR SAFETY.
1
Touch [SOURCE] on the main source screen.
The source screen appears on the display.
2
1
Touch [AUX]*
or [AUX+]*
The external input screen is displayed.
3
Touch [NTSC/PAL] to change the video input.
1
*
The name which is given as the source name in "Setting the AUX
Mode" on page 41 is displayed.
2
*
The mode which is given as the source name in "Setting the AUX+
Mode" (page 42).
• If the AUX mode is not displayed on the main menu, set AUX IN to
ON by following "Setting the AUX Mode" (page 41).
• The setting of switching NTSC/PAL, which you have set in this
section, can be used in same way in "Switching the Visual Input
Signal System" on page 41.
• The display mode changes by touching [WIDE].
For operation, refer to "Switching Display Modes" on page 30.
• After connecting the KCA-410C, its AUX input can be used only in
INTERRUPT MODE. For details, refer to the KCA-410C Owner's
Manual.
2
.
57
-EN
Hide quick links:
Advertisement
Table of Contents
