Task 2: Connect To Ethernet Port A - Cisco TelePresence MSE 8710 Installation Manual

Installing the Cisco TelePresence Server MSE 8710
The power is connected automatically as soon as you close the latches. The LCD panel displays messages
as parts are checked and eventually you see "Waiting for application to boot" after which the Cisco logo
appears followed by the IP address allocated to the TelePresence Server.

Task 2: Connect to Ethernet Port A

Connect an Ethernet cable from Ethernet Port A to an Ethernet switch (rather than a hub, to minimize
interference from other devices on the network). The Ethernet port is a 10/100/1000 Mbps auto-sensing
connection.
Note: Ethernet Ports B, C and D may not be supported in the software supplied with your blade. Do not
connect to these ports unless the web interface allows you to configure them. Do not connect multiple ports
to the same subnet unless instructed to do so by the web interface.
Cisco TelePresence Server MSE 8710 Installation Guide Page 7 of 12