Editing Pass Frequencies; Deleting Individual Pass Frequencies - AOR AR5000 Operating Manual

Notes: You can enter a PASS frequency down to the
100kHz order only (as a PASS frequency is valid within a
range of ± 10kHz). The PASS frequency can be entered
anywhere within The AR5000's receive range but it must
be noted that the search rate will slow down if the pass
frequency is entered outside of the selected program
search range as the AR5000 microprocessor will need to
check pass frequencies even if they are outside of the
program search range. It is advisable not to enter pass
frequencies outside of the selected program search range
for this reason.

13-3 Editing pass frequencies

It is also possible edit the contents of the pass list once
frequencies have been registered. This can be useful
when reviewing the contents of the pass list, to allow
changing of frequencies slightly or over-writing those not
required when you have used all 100 and want to add
another!
To access the pass menu, press and hold the
for more than one second. The legend "
be displayed with an identifying bank number or legend
" " to the right depending on whether the AR5000 is
currently in program search mode (in which case the
current bank number will be displayed) or VFO (or manual
search or simple search) mode.
Rotate the to select the required bank number
(00 ~ 19 or VFO).
Press the key to enter add/edit/delete mode. The
selected bank number will be displayed under the legend
"BANK", if in VFO mode the bank number will be replaced
by the letter " ".
If no pass channels are currently allocated for the selected
bank, the legend "- - - - - - - - - -" will be displayed.
If pass frequencies have already been registered, pass
channel numbers will have been automatically allocated
starting at 00 through 99. The first pass channel will be
PAGE 60 AR5000 OPERATING MANUAL
displayed with the legend "
bank number.
Rotate the
available empty channel may also be displayed ready to
accept data input, the legend "- - - - - - - - - -" identifies the
empty channel.
To edit the frequency of a displayed pass channel simply
key in a new frequency finishing in
i.e.
key
" will
Rotate the
process. To select another bank press the
return to the first menu and repeat the above process for
another bank.
To accept the input and complete the process, press
in either of the two menus.

13-4 Deleting individual pass frequencies

It is possible to delete individual pass channels as well as
whole banks in one go. Individual pass channels are
selected and deleted using the frequency pass menu.
To access the pass menu, press and hold the
for more than one second. The legend "
be displayed with an identifying bank number or legend
" " to the right depending on whether the receiver is
currently in program search mode (in which case the
current bank number will be displayed) or VFO (or manual
search or simple search) mode.
Rotate the
(00 ~ 19 or VFO).
" being displayed under the
to review the pass channels, the first
or
for 118 MHz.
to continue the review / selection
to select the required bank number
key to
key
" will