Deleting Program Search Banks; Search - Outline Introduction To Additional Facilities - AOR AR5000 Operating Manual

search bank is desired then override the current aerial
selection by pressing
select automatic aerial switching... of course ANT 1, ANT
2, ANT 3 or ANT 4 may be selected using this menu
(don't use , use the
Text display: To toggle the FREQUENCY / TEXT display
while in memory recall, scan and search modes press
followed by a brief press of the
To start searching program search bank 05 (or whatever
bank was last selected) simply press
you haven't set up the search bank link in any specific
way to prevent searching of bank 05). To change search
bank, rotate the
bank number if known (providing it contains data).
12-8 Deleting PROGRAM SEARCH
BANKS
Although you may overwrite program search banks
and omit them from search groups through the use of
BANK-LINK, it is also possible to DELETE all the data
from a specific bank. This may make reprogramming
new data into the bank more straight forward and may be
useful should a corruption occur.
Example of deleting program search bank - "
Press
to place the receiver into a known state of
operation.
Press then press the
second to access the DELETE menu. Press the
key three times to access the "
(or you could press the
same place).
Rotate the until "BANK
right of the LCD.
If data is already programmed into this bank the legend "*
*" will be displayed, if no data is present the legend "- -"
will be displayed.
Assuming that data is present, press
contents, after about one or two seconds delay the legend
will change to "- -" to confirm deletion. Press
complete the sequence and return to VFO mode.
instead).
key.
(providing
or key in the two digit search
"
key for more than one
" menu
key twice to get to the
" is displayed on the
to delete the
12-9 SEARCH - outline introduction to
to
additional facilities available
During program search, the AR5000 tunes to every
frequency between two specified frequency limits looking
for active interesting frequencies. When an active
frequency is located (when a signal is found and the
squelch is open) the receiver will temporarily stop
searching.
At default when shipped from the factory, the AR5000
will remain on an active frequency until the received signal
disappears and the squelch closes. The AR5000 will then
wait an additional 2 seconds in case a reply is audible
(such as aircraft and air traffic communications) then will
resume searching.
If the
the rotated, the direction of search may be
reversed. This is particularly useful for taking a second
look at frequencies which have just been searched and
for forcing the search process onward passed unwanted
frequencies.
Additional facilities are available in PROGRAM
SEARCH mode:
Program search banks may be LINKED and UNLINKED
to effectively make larger or smaller groups of program
search banks which may be searched in succession.
FREQUENCY PASS may be used so that constantly
active frequencies can be skipped when not required, they
may be reinstated at a later time.
AUTO-MEMORY makes special use of memory bank " "
so that active frequencies found while conducting a
SEARCH may be automatically written to memory (refer
to section 12-19 of this manual for further information).
This is a useful tool for compiling an activity list of rarely
used frequencies especially when unattended.
There are further parameters (in addition to BANK LINK,
PASS and AUTO-STORE) which may be changed to suit
your preferences and requirements. The list of search
defaults is shown below:
Search type
PAUSE
DELAY
L-SQ
VOICE
For further information refer to the detailed information
to
starting at section 12-13 of this manual.
keys are pressed during search or
Comment
OFF OFF and 1 ~ 60 seconds
2.0s OFF and 0.1 ~ 9.9 seconds
OFF OFF and 1 ~ 255
OFF OFF and 1 ~ 255 (*)
AR5000 OPERATING MANUAL PAGE 53