Programming And Reprogramming Search Banks - AOR AR5000 Operating Manual

12-7 Programming and reprogramming
PROGRAM SEARCH BANKS
You may wish to specify your own frequency limits or
modes for program search banks. There are 20 program
search banks in total 00, 01, 02, 03, 04, 05, 06, 07, 08,
09, 10, 11, 12, 13, 14, 15, 16, 17, 18 & 19.
Example of reprogramming a search bank - "
Let's assume that you wish to reprogram the data contents
of search bank " ": 433.000 to 433.6000 MHz, mode to
NFM, 15kHz I.F. bandwidth, 25 kHz tuning steps,
step-adjust off and comment to 70CM.
Note: The attenuator and aerial selection is made while
program search is in operation and is not programmed
into the stored data, this greatly increases the versatility
when in live use !
To make things easier for this example, first delete the
existing data.
Press to place the receiver in a known state of
operation.
Press then press the
second to access the DELETE menu. Press the
key three times to access the "
you could press the
place).
Rotate the until "BANK
right of the LCD.
If data is already programmed into this bank the legend "*
*" will be displayed, if no data is present the legend "- -"
will be displayed.
Assuming that data is present, press the
to delete the contents, after about one or two seconds
delay the legend will change to "- -" to confirm deletion.
Press to complete the sequence and return to VFO
mode.
To start programming select the data input menu by
pressing
Select the required bank by rotating the
"BANK " is displayed on the right of the LCD (for this
example). As no data exists the legend "- - - - - - - - - -" will
be displayed, if data was present the upper ("
lower (" ") frequency limits would alternatively be
displayed to warn that data was about to be over-written.
"
key for more than one
" menu (or
key twice to get to the same
" is displayed on the
, until
") and
To accept the bank location of "
programming process press
Input the lower frequency limit: The legend "
flash on the right of the LCD inviting entry of the LOWER
frequency limit.
In this example key in
strokes are echoed onto the LCD.
Note: If a mistake was made keying in previous data,
you may move backward (or forward) through the
data input selection process by holding the
key for more than one second depending upon
which way you wish to move.
Input the upper frequency limit: The legend "
now flash on the right of the LCD confirming entry of the
previous data and inviting entry of the UPPER frequency
limit.
key
In this example key in
Select the receive mode: The legend "
flash on the display (along with the legend "
right of the LCD) inviting the receive mode to be
entered. The current receive mode is displayed to the
right of the "
receiver is currently in AUTOMODE the legend "
" will be displayed. Rotate the
the receive mode, the choice is:
& . Note: the
to AUTOMODE.
" and initiate the
(set to AUTO if AUTOMODE is used)
(skipped if AUTOMODE is used)
(skipped if AUTOMODE is used)
(set to AUTO if AUTOMODE is used)
(skipped if AUTOMODE is used)
(skipped if AUTOMODE is used)
" legend. For example, if the
,
key acts as a short cut
AR5000 OPERATING MANUAL
" will
, the key
or
" will
" will
" on the
to select
, , ,
PAGE 51