Snapper 7800832 Operator's Manual page 24

The California Air Resources Board, U.S. EPA, and Briggs & Stratton (B&S) are pleased
to explain the emissions control system warranty on your Model Year 20tl-2012
engine/equipment. In California, new small off-road engines and large spark ignited
engines tess than or equal to 1.0 liter must be designed, built, and equipped to meet the
State's stringent anti-smog standards. B&S must warrant the emissions control system
on your engine/equipment for the periods of time listed below provided there has been
no abuse, neglect, or improper maintenance of your engine or equipment.
Your emissions control system may include parts such as the carburetor or fuel injection
system, fuel tank ignition system, and catatyfic converter. Atso included may be hoses,
belts, connectors, sensors, and other emissions-related assemblies.
Where a warrantable condition exists, B&S will repair your engine/equipment at no cost
to you including diagnosis, parts, and labor.
Manufacturer's Warranty Coverage:
Small off-road engines and large spark ignited engines less than or equa_ to 1.0 liter are
warranted for two years. _fany emissions-related part on your engine/equipment is
defective, the part will be repaired or replaced by B&S.
Owner's Warranty Responsibilities:
As the engine/equipment owner, you are responsible for the performance of the
required maintenance listed in your owner's manual. B&S recommends that you
retain all receipts covering maintenance on your engine/equipment, but B&S cannot
deny warranty solely for the tack of receipts or your failure to ensure the performance
of alt scheduled maintenance.
As the engine/equipment owner, you should however be aware that B&S may deny
you warranty coverage if your engine/equipment or a part has failed due to abuse,
neglect, improper maintenance, or unapproved modifications.
You are responsible for presenting your engine/equipment to a B&S distribution
center, servicing dealer, or other equivalent entity, as applicable, as soon as a
problem exists. The warranty repairs should be completed in a reasonable amount of
time, not to exceed 30 days. If you have any questions regarding your warranty
rights and responsibilifies, you should contact B&S at (4t4) 259-5262.
ii iii ii: iii !!i!!i!!iii!!i !!i!!i!iii!iii ! iiHi!iiiii!!!ii iii!ii !i !i ii!!iiiiii!i!i!i !i!i!iiii!ii !i i iiii iiiiiii iiii i!!iiii!ii !i !i !i !i !i !!i i i ii
The following are specific provisions relative to your Emissions Control Warranty Coverage. _t is in addition to the B&S engine warranty for nomregulated engines found in the
Operator's Manual.
1. Warranted Emissions Parts
Coverage under this warranty extends only to the parts listed below (the emissions
control systems parts) to the extent these parts were present on the B&S engine
and/or B&S supplied fuel system.
a. Fuet Metering System
Cold start ennchment system (soft choke)
Carburetor and internal parts
Fuel pump
Fuel line, fuel line fittings, clamps
Fuel tank, cap and tether
Carbon canister
b. Air hduction System
Air cleaner
Intake manifold
Purge and vent line
c. Ignition System
Spark plug(s)
Magneto ignition system
d. Catalyst System
Catalytic converter
Exhaust manifold
Air injection system or pulse valve
e. Miscellaneous Items Used in Above Systems
Vacuum, temperature, position, tlme sensitive valves and switches
Connectors and assemblies
2. Length d Coverage
For a period of two years from date of originat purchase, B&S warrants to the origina_
purchaser and each subsequent purchaser that the engine is designed, buitt, and
equipped so as to conform with att applicable regulations adopted by the Air
Resources Board; that it is flee from defects in material and workmanship that could
cause the failure of a warranted part; and that it is identical in all materiat respects to
the engine described in the manufacturer's application for certification. The warranty
period begins on the date the engine is originally purchased.
The warranty on emissions-related parts is as follows:
Any warranted part that is not scheduled for replacement as required
maintenance in the owner's manual supplied, is warranted for the warranty
period stated above. If any such part fails during the period of warranty
coverage, the part will be repaired or replaced by B&S at no charge to the
owner. Any such part repaired or reptaced under the warranty will be warranted
"or the renaming warranty period.
Any warranted part that is scheduled only for regular inspection in the owner's
manual supplied, is warranted for the warranty period stated above. Any such
par[ repaired or replaced under warranty will be warranted for the remaining
warranty period.
Any warranted part that is scheduled for replacement as required maintenance
tn the owner's manual supplied, is warranted for the period of time prior to the
first scheduled replacement point for that part. If the part falls prior to the first
scheduled replacement, the part wilt be repaired or replaced by B&S at no
cnarge to the owner. Any such part repaired or replaced under warranty will be
warranted for the remainder of the period prior to the first scheduled
reolacement eoint for the Dart.
Add on or modified parts that ere not exempted by the Air Resources Board
may not be used. The use of any non exempted add on or modified parts by the
owner w_ll be grounds for disallowing a warranty claim. The manufacturer will
not be liable to warrant failures of warranted parts caused by the use of a non
exempted add on or modified part.
Consequential Coverage
Coverage shall extend to the failure of any engine components caused by the
failure of any warranted emissions parts.
Clalms and Coverage Exclusions
Warranty claims shalt be flied according to the provisions of the B&S engine
warranty policy. Warranty coverage does not apply to failures of emissions parts
that are not original equipment B&S parts or to parts that fail due to abuse, neglect,
or improper maintenance as set forth in the B&S engine warranty policy. B&S is not
liable for warranty coverage of failures of emissions parts caused by the use of
add-on or modified parts.
Engines that are certified to meet the California Air Resources Board (CARB) smatl
off-road Emissions Standard must display information regarding the Emissions Durability
Period and the Air _ndex. Briggs & Stratton makes this information available to the
consumer on our emissions tabets. The engine emissions label wilt indicate certification
information.
The Emissions Durability Period describes the number of hours of actual running time
for which the engine is certified to be emissions compliant assuming proper
maintenance in accordance with the Operating & Maintenance Instructions. The
following categories are used:
Moderate:
Engine is certified to be emissions comptiant for 125 hours of actual engine running time.
intermediate:
Engine is certified to be emissions comptiant for 250 hours of actual engine running time.
Extended:
Engine is certified to be emissions compliant for 500 hours of actual engine running time.
For example, a typical walk-behind lawn mower is used 20 to 25 hours per year.
Therefore, the Emissions Durability Period of an engine with an intermediate rating
would equate to t0 to 12 years.
Briggs & Stratton engines are certified to meet the United States Environmental
Protection Agency (USEPA) Phase 2 or Phase 3 emissions standards. The Emissions
Compliance Period referred to on the Emissions Compliance label indicates the number
of operating hours for which the engine has been shown to meet Federal emissions
requirements.
For engines tess than 225 cc displacement.
Category C = 125 hours, Category B = 250 hours, Category A = 500 hours
For engines of 225 cc or more displacement.
Category C = 250 hours, Category B = 500 hours, Category A = t000 hours
24 www.snapper.com