Cisco Prisma II Technical Bulletin page 7

Downloading the New Firmware
1 Double-click SOUPLauncher.
Result: The following screen appears.
ICIM IP: Enter the IP address of ICIM2 module.

User Name: Enter the username of valid account on the ICIM2.

Auth Level: 3

Setting Up the SNMP Connection
1 Enter the appropriate SNMP read string. If it's unknown, enter "prismaread".
Enter the appropriate SNMP write string. If it's unknown, enter "prismawrite".
2
3 Verify IP connectivity and SNMP setup by clicking on "Test SNMP". If the
message "SNMP Connection OK" is displayed, go to Setting Up the FTP
Connection (on page 8).
4 Obtain the SNMP read and write string from the ICIM2.
a. Log into the ICIM2 using Hyperterm.
b. Type CLI and press Enter.
c. Type ICIM and press Enter.
d. Type SHOW COMMREAD and press Enter.
e. The SNMP read string should be displayed. Record it for later use.
f. Type SHOW COMMWRITE and press Enter.
g. The SNMP write string should be displayed. Record it for later use.
h. Re-attempt to set up the SNMP connection.
78-4032387-01 Rev C
Upgrade Procedure
7