Installing The (Optional ) Antenna; Installing The Belt Clip - Kenwood TK-2170 Instruction Manual

I
NSTALLING THE
Screw the antenna into the connector
on the top of the transceiver by holding
the antenna at its base and turning it
clockwise until secure.
Note: The antenna is neither a handle, a
key ring retainer, nor a speaker/
microphone attachment point. Using the
antenna in these ways may damage the
antenna and degrade your transceiver's
performance.
I
NSTALLING THE
Note: When first installing the belt clip,
you must remove the battery pack from the
rear of the transceiver.
1 Remove the 2 screws from the rear
of the transceiver, then remove the
small, plastic black covering that
was held in place.
2 Insert the belt clip mount into the
space on the rear of the transceiver.
3 Using the 2 screws, affix the belt
clip in place.
Note: Do not dispose of the plastic black
covering! If you remove the belt clip,
replace the covering into the space on the
rear of the transceiver. Either this covering
or the belt clip must be in place, otherwise
the battery pack may not remain installed
properly.
(O ) A
PTIONAL
B C
ELT LIP
NTENNA
9