Anti-Tip Device - GE EGR3000 Owner's Manual & Installation Instructions

Installation instructions
-&WARNING!
ANTI-TIP DEVICE
@
®
All ranges can tip and injury could result.
To prevent accidentaJ tipping of the range,
attach an approved Anti-Tip device to the
wall. (See Installing the Anti-_p Device in this
section.) To check if the device is installed
and engaged properly, carefully tip the range
forwaxd. The Anti-Tip device should engage
and prevent the range from tipping over.
If you puU the range out from the wall for
any reason, make sure the Anti-Tip device
is engaged when you push the range bacl_
agaJrtst the wall.
[] For your satety, never use yore" range lk)r warming
or heating the room. Your oven and cooktop are
not designed to heat yore" kitchen. Top bm'ners
should not be operated without cookware on the
grate. Such abuse could result in fire and damage
to your range and will w_id yore" warranty.
[] Do not store or use combustible materials,
gasoline or other flammable _;q)ors and liquids
in the vicinity of this or any other appliance.
Explosions or fires could result.
[] Do not use oven fi)r a storage area. Items stored in
the oven can ignite.
[] Do not let cooking grease or other flammable
materials accmnulate in or near the range.
LOCATION
Do not locate the range where it may be subject to slrong
drafts. Any openings in the floor or wall behind the rmlge
should be sealed. Make sure the openings around the
base of the range that supply fresh air for combustion
mad ventilation axe not obslructed by carpeting or
woodwork.
Your range, like many other household items, is heavv
and can settle into soft floor coverings such as cushioned
vinyl or caq)efing. Use care when moving the range
on this t}'pe of flooring. It is recommended that the
tollowing simple and inexpensive instructions be
tollowed to protect your floo_:
The range should be installed on a sheet of plywood
(or similar material). X4]_en the floor covering ends at
the fl'ont of the range, the area that the range will rest
on should be built up with plywood to the same level or
higher than the floor covering.
This will allow the range to be moved tor cleaning or
servicing. Mso, make sure your floor coveting will
withstand 180°E (See the Installation SafoiF Instructions
section.)
Make sure the wall coverings around your range can
withstand the heat generated (up to 200°F) by the range.
(See the Installation SafeLy
Instructions
section.)
IMPORTANT!
Remove all tape and packaging. Make sure the burners
are properly seated and level.
Take the accessory pack out of the oven and/or drawer.
Check to be sure that no range parts have come loose
during shipping.
36