Installing The Anti-Tip Device - GE JGSP23 Installation Instructions Manual

Installation Instructions
E| Anti-Tip Device
E1| Installing the Anti-Tip
Device
Before placing range in the counter, check the
factory location of the stability device on the back
of the range. This location should work for most
installations. For convenience you can hook the
stability chain in the upper set of holes. Make
sure there is no structural interference when
using the upper set of holes.
Bracket
Optional
Location
Chain
Bracket
Factory
Location
The upper set of holes are intended for use with
an optional backsplash kit. lf a backsplash kit is
being used, the stability bracket can be relocated
and put on the same time as the optional
backsplash kit. If the backsplash is not being
used, make sure that there are no countertop
structural supports which will interfere with the
stability bracket when located in the upper set of
holes.
1.
Decide on a location that has no electrical wiring
or plumbing.
Chain [/
Washer —-+—
and Screw
2. With the long screw provided anchor the chain to
the floor or wall.
CHAIN
WALL
LONG PLATE
SCREW
\ WASHER |
~_— be,
~y
Make sure the screw is going into the wall plate
or stud at the base of the wall at least 3/4".
Attach the stability chain so that it lines up with
the bracket on the back of the range.
Tug the chain to make sure it is securely fas-
tened.
Take the packaging tape and temporarily attach
the loose end of the chain to the rear of the
countertop.
Slide the range into the counter leaving enough
space behind to attach the chain to the bracket.
Slip the nearest link of the chain onto the bracket.
Pull to make sure it is as snug as possible.
Slide the range all the way back. It is normal to
have some slack in the chain, but it should not
be excessive.