Cutout For 30" Single Built-In Ovens - GE Built-In Wall Oven Installation Instructions Manual

Installation Instructions
Cutout for
30"(76.2 cm)Single
Built-In
Ovens only
For JTP30, JTP70, PT916, PT920, ZET938 models only.
Allow 11/16"
(1.75 cm) for
overlap of oven
over side edges
of cutout
21" (53.3 cm) - - "
S
Allow a minimum
of 21" {63.3 cm) for
clearance to adjacent
corners, drawers,
walls, etc. when
door is open
Cutout 7 3/4" (19.7 cm)
Width Max. Junction Box
28 1/2" (72.4 cm) Location
Min. _ (junction box
28 5/8" (72.7 cm). may be
Max. located in
---- ___ adjacent
/ cabinet)
Between IN cutout I I i
Inside Walls I [_ Height i i . 22" (56.9 cm)
Must Be
I I_ 27 1/4" Bin, to
I tN (69.2 cm) Bottom of
At Least Min.
28 112" I 1_ 27 5/16" Junction Box
(69.4
(72.4 cm) cm) Max.
Wide"
top and 1W"
(3,2 cm) overlap
of oven bottom
of cutout_-_,
Cabinet
Width
30" (76.2 cm)
"!-
Recommended
cutout location
from floor 32 1/2"
Cabinet Width
Recommended
Cutout Location
from Floor
Cutout Depth
Cutout Width
Cutout Height
If the cabinet does not have a solid bottom,
two braces or runners must be installed
level with the bottom of the cutout to
support the weight of the oven. For single
ovens, the runners and braces must
support 150 Ibs (68 Kg).
NOTE: If marks, blemishes or the
cutout opening are visible above the
installed oven, it may be necessary to
add wood shims under the runners and
front trim until the marks or opening
are covered.
These ovens are not approved for
stackable installations.
30" (76.2 cm)
32 1/2" (82.6 cm)
23 1/2" (69.7 cm) Min.
28 1/2" (72.4 cm) Min.
28 6/8" (72.7 cm) Max.
27 1/4" (69.2 cm) Min.
27 6/16" (69.4 cm) Max.
NOTE: If the cabinet does
not have a front frame and the
sides are less than 3/4" (1.9 cm)
thick, shim both sides equally to
establish the cutout width.
Suitable
Bracing
to Support
Runners --
-- 2" x 4"
(5 cm x 10 cm
or equivalent
runners level
with bottom
of cutout
-F----- 64 21 5/8-
.9 cm) Over \
Centerline
of Cabinet
Side by Side Installations
Install two wall ovens in separate cutouts.
Allow 2" (5.1 cm) min. between cutouts (PT920
models) or 6" (15.2 cm) min. between cutouts
(all other models).
Cutout - 2" (5.1 cm) Cutout -
Observe all Min. (PT920) Observe all
dimensionsl_ dimensions
and 6" (15.2 cm) and
r_lu rements. Min. requirements.
(other models
9