Cutout For 30" Single Built-In Ovens Under Counter - GE Built-In Wall Oven Installation Instructions Manual

Installation Instructions
IAICutout for 30"
(76.2cm)
Single Built-InOvens
only Under Counter
For JTP30, JTP70, PT916, PT920, ZET938 models only.
Gas or electric cooktops may be installed over this oven. See
cooktop installation instructions for cutout size. See label on
top of oven for approved cooktop models.
,\
25" (63.5 cm)
Top and/or side fillers
may be necessary
if unit is positioned
between existing
cabinets. Be sure
they are attached
securely, since they
will anchor the oven
in the cabinet.
240V / 208V
Junction Box
Location (junction
box may be in
adjacent cabinet)
7 3/4"
(19.7 cm)
\_ ,- _"Max_ madegaS cooktoP,to the left,the connections may
- 28 1/2" (72.4 cm) Min.
28 5/8" (72.7 cm) Max.
Allow 1"
overlap top
of oven,
11/16" (1.8 cm)
overlap side edges
of cutout and
1 1/4" (3.2 cm) -
overlap bottom
of oven.
Gas and electrical connections
for 30" (76,2 cm) gas cooktop must
be located in an adjacent accessible
location to the right, For 36" (91.4 cm)
be
22" (55.9 cm) Min.
Above Support
Platform
24" (61 cm)
36" (91.4 cm)
Typical
Countertop
Height
4" (10.2 cm)
Typical
Toekick
NOTE: This oven is not ap-
proved to be installed under a
solid disk, induction or
downdraft modular cooktop.
=
Side by Side Installations
Install two wall ovens in separate cutouts.
Allow 2" (5.1 cm) min. between cutouts
(PT920 models) or 6" (15.2 cm) min.
between cutouts (all other models).
Cutout- 2" (5.1 cm)
Observe all Min, (PT920)
dimensionsl_
and 6"(15,2cm) Min.
requtrements. (othermodels)
11
Cutout -
Observe all
dimensions
and
requirements.