Kenmore Dual fuel range slide-in Use And Care Manual page 20

General
Cleaning
FEATURE OVERVIEW
• To Remove and
Replace Oven Door
• Removable Outer
Door Glass Panel
To Remove
and Replace
Oven Door
1. Open the door to the fully opened position.
2. Pull up the lock located on both hinge supports and engage it in the hinge levers. You
may have to apply a little downward pressure on the door to pull the locks fully over
the hooks.
3. Grab the door by the sides, pull the bottom of the door up and toward you to
disengage the hinge supports. Keep pulling the bottom of the door toward you while
rotating the top of the door toward the range to completely disengage the hinge
levers.
4. To replace the door, reverse the door removal steps.
Make sure the hinge supports are fully engaged before unlocking the hinge levers.
The door is heavy. After removing door, lay it flat on the floor with the
inside of the door facing down.
normal
position
o
Lock engaged
for door removal
HINGE SLOTDoor
removed from the range
Removable Outer Door Glass Panel
Applicable only to models with an external glass panel not held with a frame. This design
allows you to clean the inside face of the exterior door panel as well as the hidden face of
the door inner glass.
To Remove the External Door Glass Panel:
1. Remove the door as shown above and lay the door flat.
2. Using a screwdriver, remove the 5 screws fastening the metal glass support rail to the
underside of the door. Remove the support rail.
3. Grasp both sides of the glass panel and slowly pull it out of the door upper molding.
Lay the glass flat.
To Replace the External Door Glass Panel:
1. Grasp the sides of the glass panel and carefully insert the glass into the door top
moulding.
2. Replace the support rail and the 5 locking screws.
3. Replace the door onto the range.
Handle the glass panel with care. When dropped on a corner, the glass
panel may shatter.
20