Kenmore Dual fuel range slide-in Use And Care Manual page 11

Before Setting Oven Controls
Oven Vent Location
The oven is vented at the rear of the cooktop. When the oven is on, warm air is released
through the vents. This venting is necessary for proper air circulation in the oven and
good baking results. DO NOT block the vents. Doing so may cause cooking failures, fire
or damage to the appliance.
Arranging Oven Racks
ALWAYS ARRANGE OVEN RACKS WHEN THE OVEN IS COOL (PRIOR TO OPERATING THE
OVEN). Always use oven mitts when using the oven.
To remove an oven rack, pull the rack forward until it stops. Lift up front of rack and
slide out.
To replace an oven rack, fit the rack onto the guides on the oven walls. Tilt the front of
the rack upward and slide the rack back into place.
Setting Oven
Controls
FEATURE OVERVIEW
• Before Setting Oven
Controls
• Setting Oven Controls
Setting Oven Controls
For oven settings, refer to the Electronic Oven Control Guide.
Be sure the oven is unplugged and all parts are COOL before replacing the
oven light bulb. Do not turn the oven light on during a self-cleaning cycle. High
temperature will reduce lamp life.
On some models an interior oven light will turn on automatically when the oven is
opened.
The oven light may be turned on when the door is closed by using the oven light switch
located on the Electronic Oven control.
The oven light bulb is covered with a glass shield held in place by a wire holder. THIS
GLASS SHIELD MUST ALWAYS BE IN PLACE WHEN THE OVEN IS IN USE.
Changing Oven
Light .......
To Replace the Light Bulb:
BE SURE OVEN IS COOL
1. Turn the power off at the main source.
2. Wear a leather-faced glove for protection against possible broken glass.
3. Replace bulb with a 40 Watt appliance bulb only.
4. For self-cleaning oven, press wire holder to one side to release glass shield, change
bulb and be sure to replace glass shield.
To adjust the oven temperature, refer to the Electronic Oven Control Guide. Adjusting Oven
Temperature
11