GE JSP47, JSP57, JS968 Installation Instructions Manual page 12

Installation Instructions
Installing The Range
cont.
@
@
%
SLIDE RANGE INTO OPENING
Position the range in front of the
cabinet opening.
Make sure that the glass which
overhangs the countertop clears the
countertop. If necessary, raise the unit
by lowering the leveling legs.
Push while lifting the range into the
opening, until the range is within 2"
of engaging the anti-tip bracket.
Remove the protective trim from the
side of glass (if provided).
Using the adjustable pliers or wrench,
carefully screw in the back leveling leg
until the glass overhang comes to rest
on the countertop.
[_ Then carefully screw in the front two
leveling legs (similar to E) until the
glass overhang touches the countertop.
@
Carefully push the range into the
opening until the countertop fully
engages the control panel. The back
glass overhang should cover the
cutout opening.
C onte op
Make sure the edge
of the countertop
fits flush against
the end of the
Front Control Panel
I-_ SLIDE RANGE INTO OPENING
(cont.)
®
Plug the range cord into the receptacle.
Locate the cord in the back of the range
in a manner that it will not touch or be
moved by the drawer.
Position range cord so that
there is no interference
with storage drawer
UI
///////////////////////////////////////////////
\
i --
/
/
\
. /
4.
\
III /1111
FINALCHECK OFTHE
ANTI-TIPBRACKET
When installation is
complete and the range
is in place, check to
be sure that the rear
leveling leg is fully
inserted into the slot
of the Anti-Tip Bracket.
12