GE EER3000 Owner's Manual page 32

Before YouCall ForService...
Troubleshooting -tips
Possible Causes What To Do
"F--- and a number You have a function * Press the CLEAR/OFFpad. Put the oven back into
or letter"flash error code.
ol)eratiou.
in the display
If the function code repeats. * Disconnect :ill power to the range for :it least 30
seconds and then reconnect power. If the flmctiou
citer code repeats, call tot service.
• On self'cleaning models, if a flmctiou error code
al)l)ears during the sellXcleauiug cycle, check the oven
door latch. The latch may have been moved, if ()ulv
slightly, fl'om the locked l)osition. Make sure the latch
ix moved to the right :ix flu" as it will go. Press the
CLEAR/OFFpad. _Mlow the oven to cool for one hotu:
Put the oven back into operation.
Display goes blank A fuse in your home may be • Replace the fl/se or reset the circuit breaker.
blown or the circuit
breaker tripped.
The clock is turned off
• See
the
Using the clock and timer section.
from showing in the display.
Display flashes
Power failure.
• Reset
the
clock.
Unable to get the Oven control pads were • The BAKE and BROIL HI/LO pads must be pressed
displayto show "SF" not pressed properly, at the same tiIue and held for 3 seconds.
Power outage or surge. • Reset the clock./f the oven was in use, you must reset
clock flashes
it by )ressim_ the
CLEAR/OFF
l)a(1, setting the clock
and resetting any cooking flmctiou.
"Burning" or "oily" This is normal in a new • To speed the process, set a self:clean cycle fi)r a
odor emitting from
oven and will disappear minimum of 3 hems. See the
Using the self-
the vent in time. cleaning oven section.
Strong odor
An odor from the insulation •
This
ix teml)orary.
around the inside of the
oven is normal for the first
few times the oven is used.
32