Stun Function; Biis Indication; Priority A Channel Selection - Icom VHF IC-F50 Insrtuction Manual

4
BIIS OPERATION

■ Stun function

When the specified ID, set as a killer ID, is received, the stun func-
tion is activated.
When the killer ID is received, the transceiver switches to the pass-
code required condition. Entering of the passcode via the keypad is
necessary to operate the transceiver again in this case.

■ BIIS indication

The following indications are available for the BIIS operation on an
MSK channel.

■ Priority A channel selection

When one of the following operations is performed, the transceiver
selects the Priority A channel automatically.
Priority A is selected when;
• Clear down signal is received/transmitted
- Set the "Move to PrioA CH" item as "Clear Down".
• Turning the power ON
The Priority A channel is selected each time the transceiver
power is turned ON.
• Status call
The Priority A channel is selected when transmitting a status call.
- Enable the "Send Status on PrioA CH" item in the MSK con-
figuration.
33
: Individual/group call is successful.
: Message (status or SDM) transmission is successful.
: No answer back is received.
: Appears during retry of the call (2nd call).
: End the communication.
: Operating channel is in the busy condition.