Programmable Function Keys - Icom VHF IC-F50 Insrtuction Manual

■ Programmable function keys

The following functions can be assigned to [P0], [P1], [P2], [P3],
[Red], [ ] and [
Consult your Icom dealer or system operator for details concerning
your transceivers programming.
If the programmable function names are bracketed in the follow-
ing explanations, the specific switch used to activate the function
depends on programming.
CH UP AND DOWN KEYS
• Select an operating channel.
• Select a transmit code channel after pushing the [TX Code CH
Select] keys.
• Select a DTMF channel after pushing the [DTMF Autodial] key.
• Select a scan group after pushing and holding the [Scan A Start/
Stop]/[Scan B Start/Stop] keys.
• Select a BIIS code, status number or SDM after pushing the
[Digital] key.
• Push to select the MDC menu after pushing [MDC CALL].
• Push to select the desired transceiver alias or message chan-
nel while in the transceiver alias or message channel selection
mode.
BANK SELECT KEY
Push this key, then push [CH Up] or [CH Down] to select the de-
sired bank.
SCAN START/STOP KEYS
➥ Push this key to start scanning; and push again to stop.
➥ Push and hold this key to indicate the scan group, then select
the desired scan group using [CH Up]/[CH Down].
SCAN TAG KEY
Adds or deletes the selected channel to the scan group.
] programmable function keys.
PANEL DESCRIPTION
2
2
6