1
captive screw
2
M2.5 x 5-mm screw (1)
9. Disconnect the touch-pad connector from the system board.
1 palm rest
2 touch-pad connector
10. Lift the palm rest and remove it from the computer.
Replacing the Palm Rest
1. Align the palm rest with the computer base, and connect the touch-pad connector to the system board.
2. Replace the M2.5 x 5-mm screw and tighten the captive screw.
3. Turn the computer over and replace the thirteen M2.5 x 8-mm screws.
4. Perform steps 2 through 6 in
Back to Contents Page
"Removing the Palm
Rest" in reverse order.