Table of Contents
Advertisement
Back to Contents Page
MCH Heat Sink
Dell Inspiron™ 6000 Service Manual
Removing the MCH Heat Sink
Replacing the MCH Heat Sink
Removing the MCH Heat Sink
CAUTION:
Before you perform the following procedures, see the safety instructions in the Product Information Guide.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
NOTICE:
To avoid damaging the system board, you must remove the main battery before you begin working inside the computer.
1. Follow the instructions in
"Preparing to Work Inside the
2. Remove the
Mini PCI card
(if applicable) and the
3. Remove the
hard
drive.
4. Remove the
hinge
cover.
5. Remove the keyboard.
6. Remove the
display
assembly.
7. Remove the
palm
rest.
8. Remove the
video card/thermal-cooling assembly
9. Remove the M2.5 x 5-mm screw that secures the MCH heat sink to the system board.
NOTE:
For systems with an integrated video controller, the MCH heat sink is secured by two M2.5 x 5 screws.
1 M2.5 x 5-mm screw (1) —
For computers with a
video card/thermal-cooling
assembly
2 M2.5 x 5-mm screws (2) —
For computers with a
video controller integrated
on the system board
3 MCH heat sink
Replacing the MCH Heat Sink
1. Replace the MCH heat sink on the system board.
Computer."
optical
drive.
(if applicable).
Advertisement
Table of Contents
