Advertisement
NOTE: Make sure the drain hose is lower than the horizental plane of the
drain on the dehumidifier as seen in the illustration below. Drain hose should
be as short as possible and all kinks in the drain hose should be eliminated
for proper pump operation.
.
3ft. Dehumidifier Drain Hose
X
ili //
(FIG. 17)
NOTE: If you need to cut the dehumidifier drain hose, only cut on the flat
end of the hose. Do not cut the angled end as it is designed for insertion
into the pump.
,/
X
[ l ii-
J
f
CUT
DO NOT CUT
t.
Remove flat end of the hose by squeezing the large clamp and pulling
it toward you.
2.
Remove hose from drainage joint and cut hose to appropriate length.
3.
Once cut is completed, refer to installing the Drain Hose to re-install
dehumidifier drain hose.
NOTE: If the hose end that is intended for insertion into the pump is cut
accidentally, it must have an angled end for proper water draining.
USING THE DRAIN PUMP
1.
Plug into grounded electrical outlet.
2. Place the other end of the pump hose where you would like to empty
the water (floor drain, water container or through a basement win-
dow). The pump will automatically start and begin pumping the water
that drains into it. Check hose for kinks or other obstructions.
3.
Before and after each use, check hose connections to make sure
they are properly secured.
14
Advertisement
