Table of Contents
Advertisement
installation
LP TANK TIE-DOWN
{for built-in
island
installations}
Outdoor cooking applicances require an integral
means of limiting the movement of the LP gas cylinder.
For built-in appliances which require the use of a
remote LP gas supply cylinder (island applications), a
retaining device must be created.
Lateral movement shall not exceed !" (25./4 mm) at the
retention means. The cylinder, or any portion of, shall
not become dislodged from the retention device when
a lateral force of equal weight to the cylinder is
applied, from any direction, at the center of the vertical
height of the cylinder.
Retaining device must not interfere with the operation
of the cylinder valve, and no movement shall transmit
strain to rigid tubing or pipe/hose connections. Hose
must not touch any portion of the grill/appliance.
(ANSI
Z2! 58z 2006/CGA !.6z 2006)
LPtank is insertedinto frame.
LPtank is securedwith fixed
thumbscrewon threesides.
1"Min.
TeeNut1/4-20
Recommended
(3Sides of Frame)
Thumbscrew1/4-20
right angle or spaded
2" long (3 required)
TANK DRAWER WITH LP TANK RETAINER LOOP (free-standing
models
only}
To install the LP tank, fully extend the tank drawer
and the lift retainer loop. Place the tank on the
drawer bottom, inserting the loop on the bottom
of
the tank through the hole in the drawer bottom. Tilt
the tank forward to lower the retainer loop to
engage the top ring on the tank. Insert the coupler
sleeve on the regulator
over the tank inlet; turn
clockwise to tighten.
Do not overtighten
the coupler.
Open the tank valve when ready to use the grill.
Always close the tank valve when cooking is
complete.
LP GAS GRILL CONNECTIONS
TO A GRILL OR COOKTOP
LP Gas Cooktop and Grill Combination
Connections
Use this method to connect a single tank to both
appliances.
--_ ToManifold
of Grill
3/8" Flare Tee
To Cooktop
LP gas connections
• Completely
close the main valve on the LP tank
supplying
the grill.
• Attach one hose to the cooktop
gas inlet; tighten.
• Attach one hose to the grill gas inlet; tighten.
• Attach the hose ends from the grill and cooktop to
the ends of the supplied 3/8" flare tee as shown.
• Attach the supplied regulator
hose assembly to
the 3/8" flare tee as shown.
From LpRegulated__
Tank
Note: Thesupplied hosesare
differentlengths.Connect t hemto
suityourinstallation situation.
16
Advertisement
Table of Contents
