Remove Packaging From Built-In Models - Monogram 31-10702 Installation Instructions Manual

Installation Preparation
REMOVE PACKAGING FROM BUILT-IN MODELS
1. Cut the banding. Use o box cutter or utilitg knife
to score and cut the carton along the base (or remove
the staples with a staple remover or a screwdriver).
2. Lift the carton straight up and off of the grill.
Cutthe banding
with tin snips.
-- Scoreand cut.
3. Remove all outside packing materials.
4. Remove the screws from the hold-down boards on
the skid. This will allow better access to the ends
when lifting the grill off the skid.
Boards
6. Close the lid. Cut the plastic tie holding the
wires against the left side. Let the batterg
and transformer wires hang loose along the
back side.
I
Cuttie on the rearvertical support.
,
8.
Lift the grill off the skid and slide it into the
prepared countertop opening.
Remove the tie holding the sear burner (on
some models). Lift the wire mesh cover on the
sear burner and remove packaging. Carefullg,
replace the wire mesh cover. The wire mesh
must be wrapped around the vertical side
flanges of the burner.
5. Open the lid. Cut plastic ties and bands. Remove
the parts package. Remove the grill grates and
packaging.
15