Advertisement
Remote Controller Overview and Operations
• To prevent malfunction or damage of the remote controller:
- Place remote controller at where will not be exposed to
direct sunlight or excessive heat.
- Remove batteries if the product is not going to be used for
an extended period.
- Exhausted batteries must be removed immediately, and
be disposed according to the local laws and regulations of
your region.
Remote controller holder installation
Insert
1
2
Press in
Screws
You can quickly start the operation with following 3 steps:
1
START/STOP button
2
MODE button
Switches operation mode in following order.
AUTO
COOL
Notes in HEAT mode:
• At the beginning of the operation, the indoor unit operates at very
low fan speed for about 3–5 minutes for preparation, and then
switches to the selected fan speed.
• Automatic defrosting operation overrides the heating operation when
it is necessary.
3
SET TEMP. (temperature) buttons
Set desired temperature.
Temperature setting range
AUTO
COOL/DRY
HEAT
*:Temperature control is not available in FAN mode.
4
FAN button
Controls the fan speed.
AUTO
HIGH
• When AUTO is selected, the fan speed is automatically adjusted
according to the operation mode.
5
SET button
Adjusts the vertical airfl ow direction.
6
SWING button
Starts or stops automatic swing of the vertical airfl ow direction louver.
• Each time you press the button, the vertical airfl ow direction louver
swings as follows:
COOL or DRY mode
1
2
1
2
3
4
5
6 7
Note:
SWING operation may stop temporarily when the fan in the unit is
rotating at very low speed or stopping.
3
Slide up
Pull out
DRY
FAN
HEAT
64–88 °F (18–30 °C)
64–88 °F (18–30 °C)
60–88 °F (16–30 °C)
MED
LOW
QUIET
HEAT mode
3
4
4
5
6
CAUTION
• If leaking battery fl uid comes in contact with your skin, eyes,
or mouth, immediately rinse with plenty of clean water, and
consult your physician.
• Obstacles such as a curtain or wall between the remote
controller and the indoor unit may affect the appropriate
signal transmission.
• Do not apply strong shocks to the remote controller.
• Do not pour water on the remote controller.
• Do not attempt to recharge dry batteries.
16
15
2
14
13
12
11
10
7
RESET button
When you press the RESET button, press it gently by using the tip of
a ballpoint pen or other small object in correct direction as shown in
this fi gure.
RESET
8
TIMER CANCEL button
Cancels the set timer.
9
ON TIMER button
Each time you press the button, the time changes as follows:
0.5
1.0
1.5
• Set the time while the
is blinking.
10 OFF TIMER button
Each time you press the button, the time changes as follows:
0.5
1.0
1.5
• Set the time while the
is blinking.
7
: The setting must be done within about 3 seconds during the indi-
cator stays solid.
: The button is controllable only when the air conditioner is on.
AIR CONDITIONER Wall Mounted Type
...
2.0
9.0
9.5
10
indicator on the remote controller display
...
2.0
9.0
9.5
10
indicator on the remote controller display
OPERATING MANUAL
4
3
5
6
1
7
8
9
11
12
hours
11
12
hours
(continued)
En-3
Advertisement
