Energy Saving Program - Fujitsu D’EMPLOI Operating Manual

ENERGY SAVING PROGRAM

This program automatically controls the temperature setting when there is no one in the
room for a while, and prevents electricity from being wasted.
To enable the ENERGY SAVING
ENERGY SAVING is set at the time of purchase.
Press the SENSOR button
" " on the remote controller will be displayed fl ashing.
● ENERGY SAVING is set.
● It will be on until the ENERGY SAVING setting is turned off.
To disable the ENERGY SAVING
Press the SENSOR button
" " on the remote controller will be no longer displayed.
● ENERGY SAVING is turned off.
About the ENERGY SAVING Operation
If no one enters the room for approximately 20 minutes, the set temperature will be
automatically controlled.
(When someone comes back into the room, the human sensor will detect this, and
automatically revert to the original settings.)
Operation mode
The set temperature will be increased by a maximum of
Cooling mode/Drying
approximately 4 ˚F (2 ˚C).
The set temperature will be decreased by a maximum of
Heating mode
approximately 8 ˚F (4 ˚C).
This runs the ENERGY SAVING program for the auto-
Automatic operation
matically selected mode (Cooling/ Heating/ Drying).
● Application range is follows.
Vertical angle 90° (Side view)
20 ft.
ENERGY SAVING program may not work when the room temperature is very different
from the temperature defi ned in temperature setting, such as when immediately after
starting the operation.
About the HUMAN SENSOR
Details about detection with the human sensor
The human sensor detects whether there are people in the room by
●
looking for movement by people in the room.
Notice
Since the human sensor detects infrared light given out by people, there may be cases where this detection is incorrect.
Situations in which the sensor will detect no people in the room, even when there is someone there
When the temperature is high and the difference with between people's body temperature is small.
(Such as during the summer when the temperature is
When there is someone in the room, but they do not move for a long period of time.
When someone is hidden behind a sofa, other furniture, glass, or in similar situations.
When someone is wearing extremely thick clothing and has their back facing the sensor.
Situations in which the sensor will incorrectly detect people in the room, even when there is no one there
When there is a dog or a cat moving around in the room.
When the wind is making curtains or plan leaves move.
When there is an oscillating electric fan operating.
En-10
Operating details
(if there is no one in the room for a while)
Horizontal angle 100° (Top view)
90°
50°
● When using together with the SLEEP
● During MIN. HEAT OPERATION, if
20 ft.
50°
88 ˚F (30 ˚C) or higher)
(If ENERGY SAVING is set)
(If ENERGY SAVING is off)
TIMER (P. 15), the SLEEP TIMER will
be prioritized.
there is no one in the room the set
temperature will not be changed.