Table of Contents
Advertisement
MIN. (Minimum) HEAT OPERATION
To use MIN. HEAT Operation
Press the MIN. HEAT button
The ECONOMY indicator lamp (green) will light.
To stop MIN. HEAT Operation
Press the START/STOP button
The ECONOMY indicator lamp (green) will go out.
Then the operation stops.
About the MIN. HEAT Operation
• The Heating mode will not operate if the room temperature is high enough.
• The room temperature can be maintained at
button
so as to prevent the room temperature from falling too far.
• In case of multi-type air conditioner, if other indoor unit is used for heating, the temper-
ature of the room where the "MIN. HEAT" function is applied will rise. When using the
"MIN. HEAT" function, we recommend all indoor units should be run under the"MIN.
HEAT" mode.
OUTDOOR UNIT LOW NOISE OPERATION
OUTDOOR UNIT LOW NOISE Operation mode reduces the noise level of the outdoor unit by suppressing the fan speed and the ro-
tation number of the compressor.
It is effective when the surrounding area is quiet, such as in the night.
To use the OUTDOOR UNIT LOW NOISE Operation
Press the OUTDOOR UNIT LOW NOISE button
"LOW NOISE" appears on the Remote Controller display "
To stop the OUTDOOR UNIT LOW NOISE Operation
Press the OUTDOOR UNIT LOW NOISE button
"LOW NOISE" disappears from the Remote Controller display "
Normal operation begins.
About OUTDOOR UNIT LOW NOISE Operation
• OUTDOOR UNIT LOW NOISE Operation mode can be used during cooling, heating and automatic operation. It can not be used in
FAN and DRY mode.
• OUTDOOR UNIT LOW NOISE Operation setting is saved even if the air-conditioned is stopped. Display on the remote control is
also retained.
• When the fan speed and the rotation number of the compressor of the outdoor unit have suffi ciently reduced, OUTDOOR UNIT
LOW NOISE Operation mode does not further reduce the fan speed and the rotation number of the compressor.
• Moreover, if the POWERFUL Operation is set while setting the "
ecuted after the POWERFUL Operation ends.
• When outdoor air temperature is high, it may not be operated even if it has been set.
• When compressor rotational speed and fan speed are low enough, it may not be operated even if it has been set.
• This function cannot be used for the Multi-type air conditioner. Please release it when it is set. Otherwise the signal of wireless
remote controller cannot be received.
MANUAL AUTO OPERATION
Use the MANUAL AUTO operation in the event the Remote Controller is lost or when the battery runs out.
How To Use the Main Unit Controls
Press the MANUAL AUTO button
and less than 10 seconds on indicator.
To stop operation, press the MANUAL AUTO button
About the MANUAL AUTO button
En-12
.
.
50 ˚F (10 ˚C)
by pressing the MIN. HEAT
more than 3 seconds
for 3 seconds.
, please see page 4.
While MIN. HEAT OPERATION is in
progress, only the following operation
can be used.
OPERATION
.
".
.
".
" or "
" , "
● When the air conditioner is operated
● The fan speed selected will be "AUTO"
•
SET
Indicator Lamp
TIMER
ECONOMY
: Lighting
: OFF
" or "
" will be ex-
by the controls on the MANUAL AUTO
button, it will operate under the same
mode as the AUTO mode selected on
the Remote Controller (see page 8).
and the temperature setting will be stan-
dard [76 °F (24 °C)].
Advertisement
Table of Contents
