Ur-4 Rear Panel - Samson UHF series Manual

Guided Tour - UR-4 Rear Panel
4
ANT - A
FCC ID 8GPUR - 4
MADE IN JAPAN
1: AC input - Connect the supplied standard 3-pin "EEC" plug here.
2: Balanced output* - Use this electronically balanced low impedance
(600 Ohm) XLR jack when connecting the UR-4 to professional (+4)
audio equipment. Pin wiring is as follows:
3 - SIGNAL
1 GROUND
2 + SIGNAL
* If required, both the balanced and unbalanced outputs can be used
simultaneously.
1
SAMSON
UHF RECEIVER MODEL No.UR-4
POWER
120V~60Hz 15W
RATING
SAMSON TECHNOLOGIES CORP.
MANUFACTURED UTILIZING TECHNOLOGY, LICENSED FROM CARILLON TECHNOLOGY INC.
HICKSVILLE, NEW YORK, U.S.A.
3
CAUTION
UNBALANCED
! OUTPUT
RISK OF ELECTRIC SHOCK
-10dBv.5K
DO NOT OPEN
ATTENTION: RISQUE DE CHOC
ELECTRIQUE NE PAS OUVRIR.
ATTENTION: ANTENNA CONNECTIONS ARE POWERED BY DC 9V
DISTRIBUTOR A
DBX IS A REGISTERED TRADEMARK OF CARILLON ELECTRONICS CORPORATION.
7
2 4
BALANCED OUTPUT
ANT - A
-60dBm.600
1 GND
HOT
2
COLD
3
+