Guided Tour - Da-5H Front Panel - Samson UHF series Manual

Guided Tour - DA-5H Front Panel

1
ANTENNA - A
INPUT 50
U H F
Synth Series
1: Antenna A and B mountings - Connect a pair of tuned coaxial
antennas to these mountings. Use the antennas provided with your
Samson UHF receiver, or, if unavailable, substitute the following anten-
nas only: Samson Part Number ANT 950. Third-party antennas should
not be substituted. These antenna mountings are phantom powered;
take care not to short them. See the section in this manual entitled
"Setting Up and Using the DA-5H" (on page 29) for information about
antenna installation and positioning.
2: "Power" LED - This is lit whenever the DA-5H is powered on.
3: Power switch - Use this to turn the main power on and off. When
the DA-5H is on, the "Power" LED (see #2 above) will be lit.
2
3
UHF ANTENNA DISTRIBUTION AMPLIFIER
POWER
27
SAMSON
DA-5
1
ANTENNA - B
INPUT 50