Garmin NavTalk Owner's Manual page 119

- Beacon receiver is improp-
erly connected or baud rates do not match.
- You are out of your phone
service cell or there is interference block-
ing the cell signal, phone mode turned
off or unit is scanning..
of course, beyond the limits set on the
Alarms submenu
NavTalk has detected excessive drift in
its internal crystal oscillator which may
result in longer acquisition time. The
unit should be taken to an authorized
GARMIN dealer.
space to enter new names in the PhoneBook.
acquire the necessary number of satellites to
compute a position. Try another location with
a clearer view of the sky.
cannot calculate a position due to abnor-
mal satellite conditions.Turn power off
and use other means to verify the last
position shown. Try the unit again later,
possibly in a different location.
-The NavTalk has detected
a failure in its internal memory. If the
message persists, the NavTalk is unusable
and should be taken to an authorized
GARMIN dealer.
point was received during upload trans-
fer that has an invalid identifier.
receiver hardware has been detected. If
this message persists, do not use the
NavTalk. Take it to an authorized
GARMIN dealer.
- The permanent memory
has failed and the unit is not operable.
Take the NavTalk to an authorized
GARMIN dealer.
attempted to name a route with the same
name currently in use with an existing
route. Enter a different name for the
route
- You have attempted to add
more than 30 waypoints to a route.
- You are left or right
- The
- There is no more
- The NavTalk cannot
- The NavTalk
- A way-
- A failure in
- You have
full and no additional routes can be added
from another GPS receiver or uploaded
from a PC.
being deleted was part of a route. The
deleted waypoint is removed form way-
point memory and the route.
received has been lost. You are no longer
receiving the beacon signal.
searching the sky for almanac data or the
GPS receiver is in Autolocate mode.
require service or repair. Contact
GARMIN Product Support.
- All PhoneBook
Entries, phone lists, waypoints, routes,
time, and almanac data have been lost due
to battery failure, or the receiver' s memory
has been cleared. If this condition persists
contact your authorized GARMIN dealer.
- The countdown user
timer has expired.
selected for the track log is identical to
another track log already stored in memory.
track log points in the GPS receiver ( It
holds approximately 1900 points in the
active track log) Delete unwanted track
points to make room for new entries.
is sending or receiving a GPS location to
or from another unit.
you are entering already exists in the GPS
receiver memory.
enter additional waypoint information
until old waypoints are deleted.
- Route memory is
- The waypoint
- DGPS data being
- The NavTalk is
- The NavTalk may
- The name
- You have used all
. - The NavTalk
- The name
- You cannot