Assembly; Connecting The Handle; Attachments; Power Cord Use & Storage - Kenmore Sears Destiny II 204.36997690 Owner's Manual

ASSEMBLY
The Handle/Wand Assembly has been packed
separately with the main unit. To assemble the Wand
into the Hose:
• Hold the Hose Collar tightly in one hand.
• Insert the Wand end into the Hose Collar and push
firmly until the Wand enters and slides easily into
the full length of the Hose. (Figure 2) Make sure
the Wand reaches the bottom of the Hose.
FIGURE 2
• Place the Hose/Wand Assembly into the Hose
Channel located at the rear of the machine.
(Figure 3)
• When in the channel, press the Handle down until
it locks into place with an audible click. (Figure 3a)
Nose
FIGURE 3 FIGURE 3a
On-Board Attachments
The DESTINY II vacuum cleaner carries three handy
attachments on its base. (Figures la & 4) They are:
1. A crevice tool to help you get at the most difficult
nooks and crannies.
2. A dusting brush so you can vacuum sofas,
drapes, pillows, etc.
3. A floor nozzle with an air flow adjustment feature
for cleaning either carpeted or hard floor
surfaces.
The Floor Nozzle is stored on the machine in the
Roor Nozzle Holster. (See Figure la on page 2)
Crevice
Tool
Dusting Brush
FIGURE 4 Floor Nozzle
The DESTINY II vacuum cleaner is ready to work as
soon as you connect the Handle to the unit.
Please read these instructions carefully.
IMPORTANT:
DO NOT attempt to pick up large
surface litter, cellophane, twine, or large solid
objects such as coins, paper clips, safety pins
etc. If objects such as these accidentally become
caught in the rotating brush, a loss of suction
and cleaning ability can result.
Power Cord Use and Storage
• Uncoil the Cord which is coiled tightly for shipping.
To store the Cord on the machine, wind the Power
Cord around the Upper and Lower Cord hooks.
Fasten the Cord Plug to the Power Cord by
snapping the Cord Plug Retainer over the Power
Cord. (Figure 5)
To ready the machine for use, rotate the Upper
Cord Hook to the down position, then remove the
Power Cord from the Upper and Lower Hooks.
(Figure 5a)
A Cord Retainer Clip is provided to enable the
Cord to be retained in a more convenient location.
Attach the Cord Retainer Clip onto the lower part
of the handle Grip. (Figure 6)
Note: Remember to remove the Cord from the Cord
Retainer Clip before activating the Cleaning Wand.
FIGURE 5 FIGURE 5a
Retainer
FIGURE 6 Clip
3