Careforyourmachine; Clean The Shuttle Race - Kenmore 3851278191 Owner's Manual

SECTION5. CAREFORYOURMACHINE
• Clean the Shuttle Race
This area must be kept free of dust, lint and occasional tangled thread, Clean the shuttle race area
about every three months.
Center pin of
the shuttle
Lever Bob_ _
case
Shuttle driver
Shuttle Race L
(Oil hare)
Lever
Shuttle Race
Cover
To Clean the Shuttle Area: To Replace Shuttle Assembly:
1. Raise the needle bar to its highest 1. Position shuttle race as illustrated so that shuttle
point and remove the bobbin case. driver is forming half moon on the left side of the
2; Prush:shui&_e _a,l_ tevers aside; Lift machine.
shuttle ra_ cover and take Shu_ie out.
3. Clean the shuttle race with a lint
brush.
4. Put a drop of oil on the center pin of
the shuttle and shuttle race. Do not
over-oil.
2. Hn!d _huttl_- hy P_ntpr pin _nd P_r_itJtm Chu_tl_ SO_lS
tO form a half moon on the right side. Pointed hook
will be on the bottom.
3. Place shuttle race cover into place over shuttle
assembly.
4. Snap the levers back into the original position.
37