Kenmore Sears 91441 Use And Care And Safety Manual page 2

i
i =
I
o ALL RANGES CAN TIP
INJURY TO PERSONS
COULD RESULT
INSTALL ANTI.TIP
DEVICE PACKED
WITH RANGE
o SEE INSTALLATION
KNSTRUCTIONS
STABULITY DEVICE INSTALLATION iNSTRUCTiONS
FOR BRACKET KiT NO. 342473
TOOLS NEEDED:
Phillips head screwdriver
I 3/8" open end or adjustable wrench
Bracket attaches to flooror wallto hold either right or left
rear leg leveler. If fastening to floor, be su re that screws
do not penetrate electrical wiring or plumbing, If this
cannot be determined, use shorter screws that will not
penetrate through flooring.
If the bracket came wtth your range, it is shipped tn the
prepack located Inside the oven. Remove the bracket
from the prepack and follow the Instructions below.
1. Decide whether the bracket will be Installed on the
right or left side of range location.
2. If the bracket side of the range is adjacent to a
cabinet, place the bracket agalnst back wall and
cabinet as shown In Figure 1.
If there is no adjacent cabinet, determine where the
location of the range side (palnted outside panel) will
be. Place the bracket with its outside edge at thts
location and against back wall. See Figure 1.
3. Determine whether you will anchor the bracket to the
floor or wall. Fasten the bracket securely with the
screws provided. Screws are self.drilling in wood,
plywood, particle and chip board, and most metal
framing. Ifattachlngtomasonry, youcan buy suitable
screws and anchors at hardware stores. Use a
masonry drill to drill the required holes.
4. Using the wrench, back out the four leg levelers at
least two turns. See your installation guide for more
leveling information before positioning range.
5. Slide the range into place, Be sure rear leg leveler
fully engages slot in bracket. If range cannot be
moved back far enough for rear leg leveler to enter
bracket, move bracket forward as required and attach
to floor in new locatlon.
ADJACENT CABINET OR FINAL
LOCATION OF RANGE SIDE
PANEL
OUTSIDE EDGE OF
BRACKET TO BE
FLUSH WITH LEFT OR
RIGHT SIDE OF RANGE
WALL BEHIND
RANGE
BRACKET
SCREW MUSTENTERNN_
WOOD OR METAL
WALL
PLATE
/
ATTACHMENT TO WALL
FigoI
Fig. 2
1 NCINS0t-3