Connecting; Connecting The Loudspeakers - Dynaudio Excite Owner's Manual

Fig. 1 Binding posts at rear of cabinet.
Dynaudio Excite

Connecting

Connecting the loudspeakers

1. Connect a two-pole (+/-) loudspeaker cable to the binding posts, located at rear of the
cabinet (see Fig. 1). The high quality, gold plated binding posts can accommodate
different connection systems:
– 4.0 mm banana plugs:
any tightening necessary.
– Cable spades: Un-tighten the binding posts, insert the spade into the opening, and
secure the spade by tightening the posts.
– Bare wires: Un-tighten the binding posts and place the cable into the binding
posts. Tighten the posts.
Note
• With every connection system, ensure that the contact is tight and has a proper
contact area.
• Connectors with similar gold plating as the Excite binding posts will typically offer the
best results and remain corrosion-free.
• Please ensure that the positive and negative cables do not make contact with each
other. Tighten the posts, and check the contact after a few days to make sure that it
hasn't loosened.
The pins can be put directly into the binding post without
Connecting
3