Table of Contents
Advertisement
Amplifier Loudspeaker Outputs (Example)
Fig. 3
Amplifier loudspeaker outputs (example).
Dynaudio Evidence
2. Connect the other cable ends to the loudspeaker outputs of your switched off power
Step 2:
With your amplifier switched off, connect the other end of the LEFT loud-
amp (see Fig. 3).
speaker cable to the LEFT loudspeaker outputs of the amp.
Take care to ensure the correct polarity: Choose the red (+) output and
Note:
white or black (–) output according to the loudspeaker binding posts.
Please make sure that both loudspeakers are connected properly. For a better
distinction one of the two veins of most loudspeaker cables are marked.
Keeping the amplifier switched off, connect the other end of the RIGHT
– Connect the red marked post of the speaker to the red marked output of the amp.
loudspeaker cable to the RIGHT loudspeaker outputs of the amp.
– Connect the white or black marked post to the white or black marked output
accordingly.
Take care to ensure correct polarity: Choose the red (+) output and white or
black (–) output according to the loudspeaker binding posts.
Bi-wiring/bi-amping
Dynaudio loudspeakers feature a carefully fine-tuned cross-over, optimized using
selected parts and an advanced circuitry to achieve a truly balanced and smooth
CAUTION
frequency response. Therefore, dividing the frequency sections through bi-wiring or
Ensure that the positive and negative cables (+/-) do not make
bi-amping is not recommended.
contact with each other. Otherwise your amplifier or loudspeaker
Choice of loudspeaker cable
may be damaged.
The impact a loudspeaker cable can have on sound quality may be dramatic, though in
general quality cable products will yield a quality result. Dynaudio loudspeakers are
designed to be very neutral and thus are not extremely suited to any particular type of
cable. The choice of cable is as much a factor of matching the cable to the entire audio
NOTE
system. Please consult your Dynaudio dealer for information about compatible
Ensure that the connectors have a clean contact area and that the contact is tight.
loudspeaker cables that will suit both your electronics and the Dynaudio loudspeakers.
Tighten the posts and check the contact regularly to make sure that it hasn't loosened
over time.
Connecting surround speakers
When connecting a two-channel stereo system, only the right and left channels are
Bi-wiring/bi-amping is not possible with the Evidence Platinum. Every Dynaudio loud-
connected to the amplifier.
speaker features a carefully fine-tuned cross-over, optimized using select parts and
In a surround set-up, center, side or rear loudspeakers as well as a subwoofer are
an advanced circuitry to achieve a truly balanced and smooth frequency response as
typically connected to provide for a multi-channel listening experience. Please refer to the
well as a correct phase response. Therefore, dividing the frequency sections through
amplifier's owner manual for particular connection instructions and see chapter "Multi-
channel loudspeaker setup" on page 12 for further help.
bi-wiring or bi-amping is neither recommended nor necessary.
Connecting
7
21
Advertisement
Table of Contents
