Garmin GPS 50 Owner's Manual page 67

· Remove the E-ring from the special screw under the base using a pair
of pliers.
· Remove the lever.
· Unscrew the special screw and remove it from the base.
· The base, lever, detent pin, detent spring, plastic spacer, and wave
washer may be set aside (these parts are not used for surface
installation).
· Remove the screws which mount the power/data cable and remove
the cable.
· Unscrew and remove the coinslot screw and remove the cradle.
· Drill an oblong hole in the mounting surface to allow clearance for the
power/data cable connector.
· Mount the connector plate to the dash using appropriate screws (#8
flat head screws are recommended).
· Slide the cradle onto the connector plate and install the coinslot screw.
· Install the power/data cable.
To adjust the universal mount...
C-6