8. Terminate the ring terminals to the circular backshell (item 3) by placing items on the provided
pan head screw in the following order: flat washer (provided with circular backshell), first ring
terminal, second ring terminal, third ring terminal (if needed) before finally inserting the screw
into the grounding hole on the circular backshell and securing with the provided locking nut. Do
not violate the guidelines presented in step 7 regarding ring terminals.
B.4.5 Daisy Chain, Quick-Term Shield Termination – Method B
In situations where more braids need to be terminated for a connector than three per ring terminal it is
allowable to daisy chain a maximum of two shields together before coming to the ring terminal (Figure
B-20). All other restrictions and instructions for the shield termination technique set forth for Method B.1
are still applicable.
The
maximum
4 inches.
Figure B-20. Daisy Chain, Quick-Term Shield Termination
G3X Installation Manual – Appendix B
190-01115-01
NOTE
length
of
the
combined
braids
should
be
approximately
Page B-27
Revision A