Figure 4-43 Shield Termination Methods - Garmin G5 Installation Manual

Prepare all of the shielded wires using one of the shield termination methods shown in Figure
4-43. Keep the shield drains as short as practical (3" max total length). See Table 4-4, Table
4-5, and Table 4-6 regarding numbers in parentheses in the following procedure.
1. Strip 2.5 inches (maximum) (2.0 inches maximum for 9-pin connectors) of the jacket to
expose the shield braid.
2. Remove the exposed braid.
3. Carefully score the jacket 1/4 to 5/16 inches and remove the jacket to leave the braid
exposed.
4. Slide a shield terminator (1) onto the exposed shield braid and insert shield braid drain
(14) into shield terminator. Secure the shield terminator and braid drain to the shield
using a heat gun approved for use with solder sleeves.
Garmin G5 Electronic Flight Instrument Part 23 AML STC Installation Manual

Figure 4-43 Shield Termination Methods

Page 70
190-01112-10
Rev. 9