Program Dry Operation - Daikin RXYMQ36MVJU Operation Manual

Program DRY Operation

Program DRY is a function that alternates between weak cooling and stopping the unit to remove humidity from
the air, in order to prevent the room temperature from dropping and becoming too cold.
• The microcomputer automatically controls the temperature and fan strength, so these cannot be set using the
remote controller.
• This function is not available if the room temperature is 60°F or lower.
FOR SYSTEMS WITHOUT COOL/HEAT CHANGEOVER REMOTE CONTROLLER
1.
Press OPERATION MODE SELECTOR button several times and select "
2.
Press ON/OFF button.
OPERATION lamp lights up and system starts OPERATION.
FOR SYSTEMS WITH COOL/HEAT CHANGEOVER REMOTE CONTROLLER
1.
Select cooling operation mode with the cool/heat changeover remote controller.
2.
Press OPERATION MODE SELECTOR button several times and select "
3.
Press ON/OFF button.
OPERATION lamp lights up and system starts OPERATION.
Adjustment
4.
Press AIR FLOW DIRECTION ADJUST button.
Refer to page 10 for details.
STOPPING THE SYSTEM
5.
Press ON/OFF button again.
OPERATION lamp goes off, and the system stops OPERATION.
ATTENTION:
Do not turn OFF power immediately after the unit stops. Then, wait on less than 5 minutes. Water is leaking or there
•
is something else wrong with the unit.
TEST
(only for FXFQ, FXHQ, FXAQ)
" (PROGRAM DRY Operation).
" (PROGRAM DRY Operation).
9