Daikin RXYMQ36MVJU Operation Manual page 6

ON/OFF button
1
Press the button and the system will start. Press the
button again and the system will stop.
OPERATION LAMP (RED)
2
The lamp lights up during operation.
DISPLAY "
UNDER CONTROL)
3
It is impossible to changeover heat/cool with the remote
controller when this icon is displayed.
DISPLAY " " (AIR FLOW FLAP)
4
Refer to page 10.
DISPLAY " " (SET TEMPERATURE)
F
5
This display shows the set temperature.
DISPLAY " " "
(OPERATION MODE)
6
This display shows the current OPERATION MODE.
DISPLAY " " (PROGRAMMED TIME)
7
This display shows PROGRAMMED TIME of the system
start or stop.
DISPLAY "
TEST
OPERATION)
8
When the INSPECTION/TEST OPERATION BUTTON is
pressed, the display shows the system mode is in.
DISPLAY "
CONTROL)
9
When this display shows, the system in UNDER
CENTRALIZED CONTROL.
(This is not a standard specification)
DISPLAY "
L H
10
The display shows the fan speed: "LOW" or "HIGH".
DISPLAY " " (TIME TO CLEAN AIR FILTER)
11
Refer to the operation manual attached to the indoor unit.
DISPLAY "
12
Refer to page 8.
TIMER MODE START/STOP button
13
Refer to page 11.
TIMER ON/OFF button
14
Refer to page 11.
" (CHANGEOVER
" " " " "
" (INSPECTION/TEST
" (UNDER CENTRALIZED
" (FAN SPEED).
" (DEFROST/HOT START)
INSPECTION/TEST OPERATION button
15
This button is used only by qualified service for maintenance
purposes.
Do not use it in normal operation.
PROGRAMMING TIME button
16
Use this button for programming "START and/or STOP" time.
TEMPERATURE SETTING button
17
Use this button for SETTING TEMPERATURE of the
thermostat.
FILTER SIGN RESET button
18
Refer to the operation manual attached to the indoor unit.
FAN SPEED CONTROL button
19
Press this button to select the fan speed, LOW or HIGH,
of your choice.
OPERATION MODE SELECTOR button
20
Press this button to select OPERATION MODE.
AIR FLOW DIRECTION ADJUST button
21
Refer to page 10.
NON-FUNCTIONING DISPLAY
If that particular function is not available, pressing the button
may display the words "NOT AVAILABLE" for a few seconds.
22
When running multiple units simultaneously, the "NOT
AVAILABLE" message will only be appear if none of the
indoor units is equipped with the function. If even one unit is
equipped with the function, the display will not appear.
FAN ONLY/AIR CONDITIONING SELECTOR
SWITCH
23
Set the switch to " " for fan only operation or to "
heating or cooling operation.
COOL/HEAT CHANGEOVER SWITCH
24
Set the switch to " " for cooling or to "
operation.
NOTE
• For the sake of explanation, all indications are shown on the display in
the left figure contrary to actual operating situations.
• If the display "Time to clean air filter" lights up, clean the air filter as explained
in the indoor unit operation manual. After cleaning and reinstalling the air filter,
press the filter sign reset button on the remote controller. The display will go
out.
" for
" for heating
5