Setting Remote Administration - IBM Types 2193 User Manual

2. Select Start Options and press Enter.
3. Select Startup Sequence from the Start Options menu and press Enter.
4. Select First Startup Device and press Enter.
5. Use the arrow keys to make your selection and press Enter.
6. If necessary, repeat the above steps for Second Startup Device, Third
Startup Device, and Fourth Startup Device.
7. If Automatic Power On Startup Sequence is Enabled, select the
sequence and devices from the choices provided.
8. Press Esc until you return to the Configuration/Setup Utility program
menu.
9. Before you exit from the program, select Save Settings from the
Configuration/Setup Utility program menu and press Enter.
10. To exit from the Configuration/Setup Utility program, press Esc and
follow the instructions on the screen.

Setting remote administration

You can remotely update the system programs, such as POST and BIOS,
from a network server by enabling remote administration. If you have set
an administrator password for your computer, the password does not have
to be entered in order to remotely update programs. Consult your network
administrator for information on setting up your network server to perform
POST and BIOS updates.
To set remote administration, follow these steps:
1. Start the Configuration/Setup Utility program. See "Starting and using
the Configuration/Setup Utility program" on page 3.
2. Select System Security and press Enter.
3. Select Remote Administration and press Enter.
4. To enable update remote administration, select Enabled. To disable,
select Disabled. Press Enter.
5. Before you exit from the program, select Save Settings from the
Configuration/Setup Utility program menu.
6. To exit from the Configuration/Setup Utility program, press Esc and
follow the instructions on the screen.
About this update
11