IBM Types 2193 User Manual page 204

6. At Power-On Password Changeable by User, select Yes or No. Press
Left Arrow (←) or Right Arrow (→) to toggle between selections. (If
you select Yes and an administrator password is set, the power-on
password can be changed without having to enter the administrator
password. If you select No and an administrator password is set, the
power-on password cannot be changed unless the administrator
password is entered.)
7. Select Change Administrator Password and follow the instructions on
the screen.
8. Press Esc until you return to the Configuration/Setup Utility program
menu.
9. Before you exit from the program, select Save Settings from the
Configuration/Setup Utility program menu.
10. To exit from the Configuration/Setup Utility program, press Esc and
follow the instructions on the screen.
Erasing a lost or forgotten password
Important
If possible, record the configuration information of your computer before
moving the Clear CMOS/Recovery Jumper.
To erase a lost or forgotten password:
1. Turn off the computer and all attached devices.
2. Unplug the power cord.
3. Remove the cover.
4. Locate the Clear CMOS/Recovery Jumper on the system board. (See
"Identifying system board components" on page 19 pageonly. for
location of jumper.)
5. Move the jumper from its normal position (covering pins 2 and 3) to
pins 1 and 2.
6. Replace the cover.
7. Plug in the power cord.
8. Restart the computer and leave it on until it begins to beep.
9. Turn off the computer and unplug the power cord; then remove the
cover.
10. Move the jumper back to its normal position (covering pins 2 and 3).
11. Replace the computer cover, plug in the power cord, and restart the
computer.
About this update
9