Kenmore 233.55022000 Use And Care/Installation Manual page 9

9.
Rotate baffle. Reinsert baffle into air chute (as shown) so
that baffle tabs fit all the way into slots in air chute. An
audible "click" wilI be heard when fuIIy instalIed. This will
close off the air flow through the non-ducted slots on top
of hood.
10. Re-insta!l air chute, re-connect wire harness, and replace
light panel.
NOTE: Be careful not to trap wires between _ort fin and
light panel.
SLOTS
TABS
SUPPORT FiN
11. Remove appropriate Duct Knockout_} from top or back
of hood.
TOP RECTANGULAR
DUCT KNOCKOUT
(Remove for 3¼" x 10"
Vertical & for 7" Round
Discharge)
SEMI-CIRCULAR
DUCT KNOCKOUT
(Remove for 7" Round
Discharge)
REAR
RECTANGULAR
DUCT KNOCKOUT
(Remove for 3¼" x 10"
Horizontal Discharge)
_b
3"
12. Horizontal Discharge Only: Remove the Pmate in front of
the horizontal discharge knockout. Cut the Ties, lift plate
out, and discard plate. DO NOT REMOVE the MetamStrip
held in place with two Screws.
METAL STRIP
\
PLATE
t_
_b
{b
_b
9