Camera Installation - Panasonic WV-CS580/G Installation Manual

Camera Installation

When installing the camera on a wall or a ceiling, please read the important notice below.
Important:
• Procure 4 screws (M4) to secure the camera to a wall or a ceiling according to the material of the installation
area. In this case, wood screws and nails should not be used. For mounting a camera on a concrete wall, use
an anchor bolt (for M4) or an AY plug bolt (M4) for securing. (Recommended tightening torque: 1.6 N·m)
• Required pull-out capacity of a single screw/bolt is 196 N or more.
• If a ceiling board such as plaster board is too weak to support the total weight, the area shall be sufficiently
reinforced or the Ceiling Mount Bracket for the camera, WV-Q105 (option), must be used.
The mounting conditions of the camera are described as follows:
Installation place
Ceiling
Ceiling
Ceiling
Ceiling
Wall
*1 Make sure that the installed mount bracket can support more than 5 times of the weight of the camera.
When using the optional mount bracket WV-Q105
Safety wire angle
16
Applicable mount bracket Recommended
(Direct mounting)
WV-Q105
(approx. 150 g)
WV-Q126
(approx. 1200 g)
WV-Q117
(approx. 720 g)
WV-Q118
(approx. 650 g)
Anchor bolt
(Procored locally)
Safety wire
Decorative Cover
Number of screw
screw
M4 4 pcs.
– –
M4 4 pcs.
M4 4 pcs.
M4 4 pcs.
Roof space
WV-Q105 (option)
Mounting screws
(4pcs, WV-Q105 supplied)
Ceiling board such as plaster board
Camera
Minimum pull-out
strength (per 1 pc.)
196 N
* 1
*
1
*
1
* 1