Add-In Card Options; Replacing The System Battery - IBM PC 300 2169 User Manual

Add-in Card Options

The System Board has two features that can be used if you have installed either
a fax/modem card or a network adapter card.
WOL1: Wake on LAN
If you have installed a network adapter (LAN adapter), you can use the cable
provided with the card to plug into the WOL1 connector on the System Board.
This is the Wake On LAN feature. When your system is in a power–saving
mode, any traffic through the network automatically resume the system. You
must enable this item using the Power Management page of the setup utility.
WOM1: Wake on Modem
If you have installed a fax/modem card, you can use the cable provided with the
card to plug into the WOM1 connector on the System Board. This is the Wake
On Modem feature. When your system is in a power–saving mode, any
incoming calls to the modem automatically resume the system. You must
enable this item using the Power Management page of the setup utility.

Replacing the system battery

Follow these steps to replace the battery:
1. Place the blade of a small, flat-blade screwdriver under the edge of the
retaining clip.
2. Turn the screwdriver one quarter turn, raising the clip while pressing down on
the old battery to remove it.
3. Carefully raise the retaining clip, and insert the new battery with the + symbol
facing out.
4. Insert a new 3V lithium battery IBM part number
33F8354 (battery type CR2032) into the socket and press it
down until the securing clip clicks and locks the battery in if
you replace the system battery, you need to reset the
system date and time.
Note: Before replacing the lithium battery review the lithium battery notice on
page ix.
Important: Make sure you insert the battery with the positive side on top. A
plus (+) sign indicates the positive side.
50